Collated formwork nail SMA 116/10
Formwork nail collated SMA 116/10
NL-FORMWRK-MG-(SMA116/10)-62MM
Register now and access more than 125,000 products
- 10 nails per magazine
- With pre-determined breaking point
- For pin driver with magazine
- Observe processing instructions
All nails are suitable for secondary attachments (without technical approval). The maximum tensile forces of individual attachments are at the discretion of the user and must be determined with test attachments or pull-out tests.
Datasheets(X)
 | |
Material | Steel |
Surface | Zinc plated |
Shaft length (LS) | 62 mm |
Shank diameter (ØdS) | 3.7 mm |
Length of magazine (LG) | 93 mm |
Number of nails | 10 |
Suitable for paling-board thickness (Ld) | 37 mm |
Suitable for device type | Würth BST MA-75, Hilti DX 350, Hilti DX 36M, Hilti DX 460, Hilti DX5, Hilti DX 6 |
Last viewed
Metric ratchet combination wrench with ratchet function on both the box and open ends
Lid for paint mixing cup
Bit box
Vehicle dry sandpaper SAHARA
1/4 inch + 1/2 inch tool assortment
Precision screwdriver, Philips PH
Screw cap for number plate screw
Screwdriver and extractor For valve inserts and caps
Polyester fabric adhesive tape
Metric combination wrench with POWERDRIV®