Brake fluid tester
Brake fluid tester with clamps, set
BRKFLUDTEST-EL-(DOT3-5)
Register now and access more than 125,000 products
- For all standard brake fluids (DOT3, DOT4, DOT4+, DOT5.1 etc.) and new brake fluids
- Operated through vehicle's own 12 V battery
- Measuring temperature up to +320°C via boiling point process
- Very simple user guidance through full test process on the LCD display
- Polarity protected
The brake fluid should be replaced at least every two years or if the fluid is approaching the wet boiling point!
Notes on use: Clean test tip with water after use
Datasheets(X)
The absorption of water (hygroscopy) lowers the boiling point of the brake fluid. Long braking operations may cause steam bubbles to form and could result in failure of the braking effect. The most accurate way to monitor the boiling point of the brake fluid is to use our boiling point tester. The brake fluid should be changed if the boiling point is below the recommended minimum temperature.
Last viewed
T-handle hexagon socket with ball head
Hexagon socket set screw with truncated cone ISO 4026 steel 45H, plain
Circlip For shafts, standard design, shape A DIN 471, spring steel, phosphated and oiled
Injectable mortar WIT-PE 500 WIT-PE 500 for concrete and post-installed rebar connection
Flat washer For hexagon head bolts and nuts DIN 125, A4 stainless steel
Tyre profile depth gauge
Countersunk head screw with recessed head, H DIN 965, steel 4.8, plain
1/2-inch impact socket wrench insert hexagon, metric, short
Metric double box-end wrench with POWERDRIV®
Hexagon head serrated screw with flange W-0274, steel 8.8, zinc-plated, blue passivated (A2K)