Separator
Separator tool
SEPRTL-SPNW155MM
Register now and access more than 125,000 products
- This separator is used if puller hooks cannot reliably grip the part being extracted as it is seated too closely. The separating blades are mounted between the parts and pressed against each other. The wedge shape of the separating blade separates the assembly.
- The separator can also be used to remove thin parts, as the pull-off force acts on a large area. Prevents undesirable deformations and damage. The separating blades are mounted with the flat surface under the part to be removed.
- Drop-forged and hardened separating blades
- High-strength clamping screws
Datasheets(X)
 | |
Min./max. internal clamping width (A) | 30-155 mm |
Width of clamping jaw (B) | 215 mm |
Spindle length (C) | 310 mm |
Min./max. hole distance (E) | 137-262 mm |
Material of separating blade | Vanadium steel |
Surface of the separating blade | Zinc plated |
Thread dimension | M18 x 1.5 |
Last viewed
Pin punch set, large dimensions 5 pieces
1/2" socket wrench insert metric, bi-hex, short
Stepped lever Made of shatter-proof and impact-resistant special plastic
Angle grinder, pneumatic, spare parts
Crepe masking tape
Foam roller WB For water-based paints
Pan head screw with H cross recess DIN 7985, A2 stainless steel, plain
3/8-inch socket wrench insert, metric long
Hexagon Socket Head Cap Screw ISO 4762/DIN 912, steel 8.8, zinc-plated, yellow chromated (A2C)
Wire end ferrule with plastic sleeve according to DIN 46228 Part 4