Welcome to Würth India For trade customers only

Mould release agent For thermoplastics and thermosetting plastics

Mould release agent
MOULDRLSEAGNT-SILICONEFREE-400ML

Art.-no. 089050
EAN 4046777028966
Prices for customers after login
Mould release agent For thermoplastics and thermosetting plastics

Art.-no. 089050

Prices for customers after login
Quantity
PU

Exclusively for trade customers

Register now and access more than 125,000 products

  • Can be used up to +120°C

  • Greatly reduces rejects

  • Physiologically safe

  • Washes off easily

  • Subsequent treatment of injection moulded parts such as printing, painting and metallising etc. is possible

  • Slight deformation of injection-moulded part

  • Silicone-free
Notice

Store the product in a dry place at a room temperature of 20° C. Shelf life of 24 months.

The usage instructions are recommendations based on the tests we have conducted and based on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

Product information

Datasheets(X)

Certificates/ Documents

 | 

 | 

Application area

For thermoplastics and thermosetting plastics

Instructions

Briefly and evenly spray the open metal moulds. As the solvents evaporate quickly, the injection moulding machines can be started immediately after spraying. Even narrow openings are sufficient for the fine spray jet to reach all parts of metal moulds.


Caution: Do not apply to hot surfaces (T ≥ 50° C)!

Contents

400 ml

Colour

Colourless

Smell/fragrance

Characteristic

Chemical basis

Mineral oil

Shelf life from production

24 Month

Conditions to maintain shelf life from production

dry storage area, 20°C

Silicone-free

Yes

VOC concentration (CH)

93 %

AOX-free

Yes

Max. temperature conditions

120 °C

Density

0.568 g/cm³

Density conditions

at 20°C

Suitable glove:
 
Product
Description
Nitrile chemical protective glove With cotton velour finish inside
Nitrile chemical protective glove With cotton velour finish inside
Description:
Permeation level: 6
Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.
Measured breakthrough time
Permeation level
< 10 min
0
≥ 10 min
1
≥ 30 min
2
≥ 60 min
3
≥ 120 min
4
≥ 240 min
5
≥ 480 min
6

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.

Art.-no.
Cust. Mat. No.

Hazardous Material

Product information

Datasheets()

Datasheets ()

CAD data  | 

Certificates/ Documents

 | 

 | 

Technical information